DESIGN AND CONSTRUCTION OF AUTOMATIC FENCE LIGHT CONTROLLER
ABSTRACT
The very fundamental reasons behind this project assignment is to expose student to the very important aspect of private and independent research work not only theories but also subsequent translation of the theoretical research work into a particular function system.
The project construction of automatic fence light controller has been done primarily as a photo type design it could be further modified suit the situation where it will be used e.g when used to activate an alarm the led could be further modified to suit the situation where it will be used e.g when used to activate an alarm the led could be replaced with a relay and feedback resistor removed (for greater sensitivity)
Title Page
Approval Page
Abstract
Table Of Contents
Acknowledgement
Dedication
Chapter One
1.1 Introduction
Chapter Two
2.1 Description Of Components Used
2.2 Integrated
2.3 Transistor
2.4 Diode
2.5 Resistor
2.6 Variable Resistor (Preset)
2.7 Capacitor
2.8 Light Dependent Resistor (Ldr)
2.9 Relay
2.10 Transformer
Chapter Three
3.1 Circuit Drawing Of The Automatic Fence Light Controller
3.2 Achieve Function Of The Alto Fence Light Controller
3.3 Rectification Stage Of The Circuit
Chapter Four
4.1 Principles Of Operation Of The Automatic Fence Light Controller
4.2 Project Component /Materials Cost & Packaging
Chapter Five
5.1 Test Measurement And Observation
5.2 Conclusion And Recommendation
References.
Copyright © 2023 Author(s) retain the copyright of this article.
This article is published under the terms of the Creative Commons Attribution License 4.0
If you like this article, see others like it:
- Optimization of Battery Management System (BMS) for Nanosatellite
- Development of Software for Life Cycle Cost Analysis of Solar Photovoltaic and Diesel Generator Systems in Nigeria
- Design and Construction of 1.5 KVA Inverter
- Construction of Step Up Transformer with Multi-Output
- Construction of Battery Charge Control for Photovoltaic Systems